CVE-2026-19741: OpenThread joiner autostart uses a publicly documented default Joining Device Credential (PSKd)
Noroxi assessment
Priority: Monitor (action score 30/100)
- The sources we track (CISA KEV, Exploit-DB, Metasploit, Nuclei, GitHub) show no public exploit code or exploitation in the wild.
- Probability of exploitation in the next 30 days: 0.26% (FIRST EPSS).
- Someone on the same network segment can trigger it. No account or password is required. No user action is required. Special conditions such as timing or configuration are required.
- Fixed version: zephyrproject zephyr 4.5.0.
Low priority for now. Upgrade to zephyrproject zephyr 4.5.0 or later.
Generated automatically from the record's data: CVSS (NVD and CNA), CISA KEV and SSVC, FIRST EPSS, exploit sources, fixed versions. How we calculate it
Primary sources: NVD · CVE.org · FIRST EPSS
Zephyr's OpenThread integration defined CONFIG_OPENTHREAD_JOINER_PSKD with default "J01NME" in modules/openthread/Kconfig.thread (previously subsys/net/l2/openthread/Kconfig, then subsys/net/l2/openthread/Kconfig.thread). J01NME is the example Joining Device Credential used throughout the public OpenThread and Thread commissioning documentation, including Zephyr's own samples/net/sockets/echo_client/README.rst, so it is not a secret. A firmware image built with CONFIG_OPENTHREAD_JOINER_AUTOSTART=y that never overrode the PSKd therefore shipped with a publicly known joining credential compiled in, with no build-time or run-time warning. The PSKd is the only value that authenticates Thread commissioning: joiner and commissioner run a DTLS-PSK handshake keyed on it, after which the commissioner supplies the full operational dataset. In ot_configure_instance() (modules/openthread/openthread.c), a device with no stored dataset calls otJoinerStart() with the configured PSKd, and ot_joiner_start_handler() calls otThreadSetEnabled() on success. An unauthenticated attacker within 802.15.4 radio range of an uncommissioned device (factory-fresh, after a factory reset, or after a settings erase) can run any stock Thread commissioner registered with J01NME, complete the handshake, and hand the device an attacker-controlled operational dataset. The device then joins and enables Thread on the attacker's mesh. The attacker becomes its router, seeing, dropping, injecting and spoofing all of the device's IPv6 traffic and impersonating the peers the application expects, while the device is cut off from the network it was meant to join and stays mis-provisioned until it is reset. Only application-layer security with independently provisioned credentials survives. Exposure is limited to builds that enable joiner autostart and leave the PSKd unset; the option is not enabled by default and no in-tree sample uses the vulnerable combination. The fix removes the default from CONFIG_OPENTHREAD_JOINER_PSKD and adds a BUILD_ASSERT() in modules/openthread/openthread.c, active only under CONFIG_OPENTHREAD_JOINER_AUTOSTART, that fails the build unless a 6-to-32-character PSKd is configured. Products should provision a per-device PSKd from factory data and call otJoinerStart() from the application rather than relying on a credential compiled identically into every unit.
- Published
- Oct 23, 2026
- Updated
- Nov 2, 2026
- EPSS
- 0.2% · 18th percentile
- CWE
- CWE-1392
Report tools
Action score
30
Monitor
Low priority for now.
- CVSS
- 30 / 40 · 7.5 / 10
- CISA KEV
- 0 / 30 · Not listed
- EPSS
- 0 / 30 · 0.2%
CISA SSVC decision
- Exploitation
- none
- Automatable
- no
- Technical impact
- total
Vulnrichment: CISA's decision-tree inputs.
CNA vs NVD score
- NVD
- —
- CNA · zephyr
- 7.5
- NVD has not scored this yet; the score shown is the CNA’s.
The score given by the assigning authority versus NVD’s independent score. A gap means the severity is contested.
Get told when this record changes
- Not in KEV: no record of exploitation in the wild
- No public exploit code on record
- A fix has been released
If any of these changes, we'll tell you in the daily email digest.
Running WordPress? Scan your site free with WP Lens
Noroxi analysis
What does it mean in your environment?
The assessment above is generated automatically from the record's data; it doesn't know your environment. Our team verifies on your systems whether this vulnerability is actually exploitable and which mitigation is enough.
We use this product, ask for helpAffected systems
Is your version affected?
Pick the product and type the version you run. It's compared with this record's version ranges in your browser; the version isn't sent anywhere.
—
Versions reported by the vendor
Affected version ranges reported by the assigning authority (zephyr). Independent of NVD's CPE analysis and usually ahead of it.
zephyrproject zephyr
- 1.14.0 and later · before 4.5.0affected · semver
Same product
zephyrproject: all recordsOther highest-scoring records for the same primary product.
- CVE-2023-4260Potential off-by-one buffer overflow vulnerability in the Zephyr FS subsystem40Plan
- CVE-2021-3625Buffer overflow in Zephyr USB DFU DNLOAD40Plan
- CVE-2020-10071Insufficient publish message length validation in MQTT40Plan
Published before and after this one in the same product
- ← EarlierCVE-2026-78119Oct 21, 2026 · Out-of-bounds write in the Nuvoton NPCX eSPI Target-Attached-Flash receive path from an unvalidated host-supplied packet length25Monitor
- ← EarlierCVE-2026-79976Oct 21, 2026 · NULL pointer dereference in the MCTP I2C+GPIO target binding triggerable by a peer I2C controller28Monitor
- Later →CVE-2026-79977Oct 23, 2026 · WireGuard peer endpoint learned from unauthenticated transport-data messages allows off-path tunnel hijack in Zephyr32Monitor
Remediation
Which version to upgrade to
Fix versions compiled from the vendor, package registries and Microsoft. Verify the vendor's note before upgrading.
| Product / package | Fixed version | Source |
|---|---|---|
| zephyrproject zephyr | 4.5.0 | Vendor (CNA) |
Exploit status
No known public exploit
No public exploit has been observed yet. That doesn't mean you're safe, only that the bar is a little higher.
Research context
For pentesters and researchers: attack profile, score disagreement, timeline, patch commits, credits, variant and chain candidates, bug bounty scope. All derived from existing data; no exploit code.
Timeline
From publication to today: proof of concept, Metasploit module, CISA KEV and fix record. Dates are as reported by the sources.
- Published
- Fix recordedsame day
- TodayNov 2, 2026+10 d
FIRST EPSS daily score; only changes of 0.01 or more are recorded (step chart).
Patch and commit links
Commit, PR and diff links among the references. A starting point for patch-diffing and variant hunting; fixes, not exploits.
Credits
All researchersFinders, reporters and analysts named in the CNA record. Click a name for that researcher’s other records.
No credits in the CNA record.
Variant candidates
Same product, same weakness class, within 18 months. If the patch missed the root cause, the sibling bug is here.
No nightly-computed relations.
Chain candidates
An authentication bypass and a privilege-requiring bug in the same product, published close together: combined they may become an unauthenticated path.
—
Bug bounty scope
No known public program.
Source: bounty-targets-data (public HackerOne, Bugcrowd, Intigriti, YesWeHack listings).
Technical details
Attack conditions
- Someone on the same network segment can trigger it.
- No account or password is required.
- No user action is required.
- Special conditions such as timing or configuration are required.
If successful
- Confidentiality
- high · data can be read
- Integrity
- high · data or configuration can be modified
- Availability
- high · the service can be disrupted
- Attack vector
- Adjacent
- Attack complexity
- High
- Privileges required
- None
- User interaction
- None
- Scope
- Unchanged
- Confidentiality impact
- High
- Integrity impact
- High
- Availability impact
- High
Weakness class (CWE)
CWE-1392 · Use of Default CredentialsCVSS vector
CVSS:3.1/AV:A/AC:H/PR:N/UI:N/S:U/C:H/I:H/A:H
nvd-secondary
Attack context
MITRE CAPEC attack patterns and ATT&CK techniques for this weakness class (CWE). A starting point for detection rules and threat hunting.
MITRE has no CAPEC/ATT&CK mapping for this CWE.
Change log
- SSVC exploitation— → none
- Exploit maturity— → none
- Fix✗ → ✓
For records you follow, these changes also arrive as notifications. →
References
Show all references (1 more)Show less
Vendor advisories and official records. Exploit/PoC links are deliberately left out.